This Standard commences on the day after it is registered. This standard applies to the design and construction of vehicles as set out in clauses C. For the purposes of clause C. Vehicle Category. ADR Category Code . Manufactured on or After. Acceptable Prior Rules. Moped 2 wheels. Not applicable. Moped 3 wheels. Motor cycle. Motor cycle and sidecar. Motor tricycle. Passenger car.
Forward-control passenger vehicle. Off-road passenger vehicle. Light omnibus. Heavy omnibus. Light goods vehicle. Medium goods vehicle. Heavy goods vehicle. For vehicle categories, definitions and meanings used in this standard, refer to:. Definitions in Section 2 of the standards specified in clauses This shall be in the centre rear seating position, if applicable; and.
Notwithstanding clauses For guidance to vehicle manufacturers the clearance parameters shown in Figure 7 are sufficient to demonstrate compliance with Clause The information shall include:. Under no circumstances are they to be used for adult seatbelts, harnesses, or for attaching other items or equipment to the vehicle. Orientation shall be shown relative to the front of the vehicle. Details of the dedicated anchor fitting package in accordance with clauses The requirements of clause Subject to Clause For guidance to vehicle manufacturers, the clearance parameters shown in Figure 8 are sufficient to demonstrate compliance with Clause The static test load of 3.
The test dummies shall each have a mass of not less than The test rig shall have a mass of not less than kg and shall meet the requirements of clause The test dummies shall be restrained in accordance with the requirements of clause In addition to the requirements of clauses Except for convertible vehicles  :.
For convertible vehicles:. For the purposes of this standard:. Each ISOFIX top tether anchorage must also meet the information, location, accessibility and strength requirements of clauses Where a vehicle manufacturer elects to incorporate a specific vehicle child restraint in a vehicle, it must comply with the relevant general and particular technical specifications of United Nations Economic Commission for Europe Regulation UNECE No.
Dimensions in millimetres. Dimensions in mm not to scale. Dimensions in millimetres not to scale. Each view can be rotated about an axis passing through point X and perpendicular to the page. Dimensions in mm except where otherwise indicated.
Drawing not to scale. If not adjustable , the side view may be rotated about an axis passing through Point Y and perpendicular to the page. The Table of Amendments provides a history of clauses that have been amended, inserted or deleted. This vehicle standard is determined under section 7 of the Motor Vehicle Standards Act This takes the format of old no.
The category code may also be in the format L 1 , L A etc. Construction of Vehicles R. Skip to primary navigation Skip to primary content. FC Table of contents. For vehicle categories, definitions and meanings used in this standard, refer to: This shall be in the centre rear seating position, if applicable; and The information shall include: Except for convertible vehicles  : For convertible vehicles: For the purposes of this standard: This standard is being made to set safety requirements for any ISOFIX based child restraint anchorages that are fitted to a vehicle and allow vehicle manufacturers the option of providing and testing child restraint anchorages of the ISOFIX type.
Administered by: Infrastructure, Regional Development and Cities. Start Date. Name of Instrument. Registration Date. Commencement Date. Clause affected. How affected. Amending instrument. Amendment 1.